Skip to main content

What you need

This teardown is not a repair guide. To repair your Scanmaker Air, use our service manual.

  1. Scanmaker Air Teardown, Prying open: step 1, image 1 of 1
    • I used flat 2 out of the IFixIt kit I have. Slide it from USB down on both sides of device. Likely could be done better with other tools

  2. Scanmaker Air Teardown, Internal clips: step 2, image 1 of 1
    • Mindful of these. I'm not sure at writting how delicate they are

  3. Scanmaker Air Teardown, Inside look: step 3, image 1 of 1
    • Left is "front". Right is "back"

  4. Scanmaker Air Teardown, Replacing + putting together: step 4, image 1 of 1
    • I was mostly straight up and down with a slight angle to wiggle the USB port down. Bottom of plastic housing to battery side. I placed the orange tip after. Then snap housing back on. Feel is different but may still work (I tore down 2 that are unknown cause of failures). Make sure orange part is in before placing housing back on

Bookworm 3616

Member since: 07/27/23

26 Reputation

1 Guide authored


Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 43

All Time: 51